* Add car port: Kia Niro Plug-In Hybrid 2018
* Add additional FW version
* Low speed lockout 32 MPH
* Add test route
* min_steer_speed in CarInfo
* Remove min_steer_speed from CarInfo
* Add to CARS.md
* run generator
* update min enable speed and regen
* update ci routes
* these are the same car
* i think we only add a note if it's a new platform
* fix HEV -> PHEV
* Add test route
* dup fw
* haha we already support this car in #25187
Co-authored-by: Shane Smiskol <shane@smiskol.com>
old-commit-hash: 03b074426a7de22b9f5dbfb9bb30f8325ac43b4a
* back to actual information
* remove some star code
* round speeds
* Try out showing lateral acceleration
* remove that
* Fix speed units
* Add harness and try rounding to nearest half before scapping it
fix
^2
^2
* Add back steering torque star
* Fix static analysis
* auto-generate header
* fix static analysis. set to Harness.none by default
* rm
old-commit-hash: 747bcb013dabdb1f220dc97a37270b42cb4eae03
* Update values.py
Adding 2022 Santa Fe Limited drive train and sensors - 2.5T with Dual Clutch Transmission which is different than the SE/VRT/SEL models.
* Update selfdrive/car/hyundai/values.py
* Add back other FW
Co-authored-by: Shane Smiskol <shane@smiskol.com>
old-commit-hash: 5f8858266c4127ddd2df851c66678982667fc06b
* added missing FW for 2022 Elantra SEL
I connected the Comma 3 with Hyundai K Harness and the vehicle was unknown. I worked my way through fingerprint 2.0 and compared the FW I had with this file and added the missing firmware to the Elantra_2021 section. I then went for a drive and it worked as intended. A number of the fwVersion were already there and so I've only added the ones that were missing.
* removed erroneous entries
removed entries that were not labeled Hyundai that I had added.
old-commit-hash: c870d0cbdeacc3ab6c3e460fdc484c1961a5b2a0
* see if this works at all
* can revert this
* think adding a no entry conditionally is nicer
* then we can revert this
* 0 makes more sense
* Revert "0 makes more sense"
This reverts commit efc89e8a2389ef58fbc0cec0a2872d24db524867.
* gm CC uses > 70
* bump cereal
* comment
* test on Honda
* whoops
* works
* add exception with todo
* moved button enable events to controlsd
* get rid of that
get rid of that
* different values for now
* car interfaces add enable event, controlsd can block it
* Regen and update refs
* delete if not set
* One place
one place
* regen routes are uninitialized first few frames
* Trim start of segment so it's like original segment
* stash
* regen
* not working
* clean up
* more cleanup
* revert
* bump ceral
* actually check resume button
* whoops
* pcmCruise cars don't use setSpeed, so we're good
* engage correctly in sim
* Update ref_commit
* Update refs
old-commit-hash: 5ed587ebeff24bacf70c44879616c51756730bba
* Chrysler: ensure control bit is high before torque cmd
* move that & update refs
* check control bit too
old-commit-hash: e0e0aad144f1e47486faa8c06d54d29c3dd94c79
* push
* do process replay
* commit
* update refs
* clean up
* clean up controlsd
* clean up controlsd
* Add assert
* debubuggier param name
* can be peristent
* Revert "can be peristent"
This reverts commit 6e6d3f6423c26a202623cef728e038259e9e46cd.
* Update selfdrive/test/process_replay/process_replay.py
old-commit-hash: 87ca42e993f1cc96cc313e33b3c538143e0a737c
* VW PQ: Volkswagen Passat NMS
* regen CARS.md
* vEgo from Bremse_1 vehicle speed
* sync opendbc to master
* handle checksums and counters in opendbc
* LDW HUD message handling
* GRA_Neu_Zaehler -> COUNTER
* bump opendbc
* stub in till we find platform ACC standstill
* bump opendbc
* bump opendbc
* placeholder lateral accel data
* regen CARS.md
* counters now directly supported in opendbc
* additional door-open signals
* add trunk lid state
* add doors and trunk lid to signals list
* LDW_Status updates and passthrough
* bump opendbc for typo fix
* update AWV comment
* another comment update
* regen CARS.md with PQ in dashcam only
* don't show NMS footnotes while still in dashcam
* polish
* add stubbed-out dashcamOnly prep
* VW MQB: Cleanup stock ACC button handling
* bump opendbc and panda
* use controls resume output as trigger
* these can wait until taco bell
* bump opendbc
* pass through of previously fixed value
* retry CI
* checks already done in carcontroller
* don't need these anymore
* reduce diff for now
* slightly better abstraction
* more engine and trans FW
* turn signal is instantaneous stalk position
* weak sauce :(
* better clarity
* try torque tune
* add test route references
* bump opendbc and panda for OP long
* don't show steering faults for 3 seconds after start
* longitudinal control senders
* a little more torque
* test hax to torque control
* test a little more delay
* allow use of manufacturer ramp-up rate
* soften wheel-touch threshold
* Revert "test hax to torque control"
This reverts commit d1af459c29e36264aae406f72b8fcbc9ef22b9e0.
* punch it Chewie
* better ACC state and mainswitch handling
* a little more
* tweak max accel gradient
* oops
* also oops
* stuff
* srsly
* that's not how this works
* regen CARS.md
* footnotes now properly excluded for dashcam cars
* this wasn't a problem
* update network location detection
* bump submodules for ACC main switch
* clean up DBC references and long flag
* bump one more time
* one more time
* follow CANPacker counter refactor
* bump opendbc
* sync opendbc to master
* bump panda to fix Subaru tests
* DBC handling cleanup
* fix
* model-year stretch
* cleanup and rate bugfixes
* better abstractions
* simplify create_lka_hud_control
* volkswagencan -> mqbcan
* bump panda
* fix doc data bug, regen CARS.md
* style updates; diff reduction
* use common button enable logic
* not needed anymore
* refactor TSK and HUD enum values
* make common button events function
* consistency
* bump panda
* bump panda
* dashcam only
* don't need process_replay yet
* regen CARS.md with Passat NMS in dashcam
* can't handle dashcam-orphaned footnotes yet
* remove outdated standstill handling
* editor tried to be too helpful at some point
* don't need to import this anymore
* Apply suggestions from code review
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
* follow parkingBrake refactor
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
old-commit-hash: c27d7913f2db43ec668dd068199bc568802dd809
* Hyundai: Kona EV 2022 torque tune
* Update selfdrive/car/hyundai/interface.py
* update for all
old-commit-hash: 0258ef74ff52b9f2d545537c05984de1b75252f8
* fix log paths ref printing in process replay
* rm that
* this is easier to read
* fix model_replay
old-commit-hash: 4602e5a8f9e23f173635e9e00a60ab3b73deb254
* Add video link for Santa Fe 2022
* Update selfdrive/car/hyundai/values.py
Co-authored-by: Shane Smiskol <shane@smiskol.com>
old-commit-hash: df48ab9ee28a28173e3e84f6e7c5da585469de28
* Don't set lane change events if we're not able to steer.
* more specific variable name
* update process replay socket config
Co-authored-by: Adeeb Shihadeh <adeebshihadeh@gmail.com>
old-commit-hash: 5b1ba4f1357ac7f385ee47c78b38cfb81bef42ab
Shane Smiskol